No Hot Water? Troubleshooting Tips

---

If you find yourself without hot water, follow these steps to identify and possibly resolve your hot water issues before calling a professional.

Step 1: Check for Leaks

• Inspect your hot water system for visible signs of leakage.
• If you find any leaks, contact a licensed plumber immediately, as this could indicate a serious issue.

Step 2: Ensure the Tank is Full

• If there are no leaks, check if the tank has enough water.
• Locate the filler valve on the side of your hot water system.
• Lift the lever until water starts to overflow from the designated overflow pipe. CAUTION: The water may be hot, so be careful.
• Wait a few hours for the water to heat up after refilling.

Step 3: Check the Power Supply

• If water overflows immediately after operating the filler valve, your system may not be heating properly.
• Check that the power supply is switched on.
• Inspect your switchboard to ensure the circuit breaker for the hot water system is in the ON position.

Step 4: Contact a Technician

• If you've checked the water level and power supply but still have no hot water, contact a professional technician for assistance. You can reach out to Jentech Electrical at 07 3914 9696 to schedule a service.

Additional Tip:

• If the switches are ON, but your water is only lukewarm or fluctuates between hot and cold, it is likely a valve issue rather than an electrical problem. In this case, you may need a licensed plumber to inspect and replace faulty valves.